YASKAWA T1000A, Техническое руководство, Страница: 201 / 517

5.7 H: Terminal Functions
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual 201
P
a
ra
me
te
r D
e
ta
ils
5
u
H3: Multi-Function Analog Inputs
The drive is equipped with three multi-function analog input terminals: A1, A2, and A3. See Table 5.23 for a listing of
the functions that can be set to these terminals.
n
H3-01: Terminal A1 Signal Level Selection
Selects the input signal level for analog input A1.
Setting 0: 0 to 10 Vdc
The input level is 0 to 10 Vdc. The minimum input level is limited to 0%, so that a negative input signal due to gain and
bias settings will be simply read as 0%.
Setting 1: –10 to 10 Vdc
The input level is –10 to 10 Vdc. If the resulting voltage is negative after being adjusted by gain and bias settings, then
the motor will rotate in reverse.
n
H3-02: Terminal A1 Function Selection
Selects the input signal level for analog input A3. See Refer to Multi-Function Analog Input Terminal Settings on
page 204 for instructions on how to adjust the signal level.
n
H3-03, H3-04: Terminal A1 Gain and Bias Settings
Parameter H3-03 sets the level of the selected input value that is equal to 10 Vdc input at terminal A1 (gain).
Parameter H3-04 sets the level of the selected input value that is equal to 0 V input at terminal A1 (bias).
Both can be used to adjust the characteristics of the analog input signal to terminal A1.
Setting Examples
• Gain H3-03 = 200%, bias H3-04 = 0, terminal A1 as frequency reference input (H3-02 = 0):
An input 10 Vdc will be equivalent to a 200% frequency reference and 5 Vdc will be equivalent to a 100% frequency
reference. Since the drive output is limited by the maximum frequency parameter (E1-04), the frequency reference will
be equal to E1-04 above 5 Vdc.
Figure 5.67
Figure 5.67 Frequency Reference Setting by Analog Input with Increased Gain
• Gain H3-03 = 100%, bias H3-04 = -25%, terminal A1 as frequency reference input:
An input of 0 Vdc will be equivalent to a -25% frequency reference.
When parameter H3-01 = 0, the frequency reference is 0% between 0 and 2 Vdc input.
When parameter H3-01 = 1, the motor will rotate in reverse between -10 and 2 Vdc input.
No. Name Setting Range Default
H3-01 Terminal A1 Signal Level Selection 0, 1 0
No. Name Setting Range Default
H3-02 Terminal A1 Function Selection 0 to 41 0
No. Name Setting Range Default
H3-03
Terminal A1 Gain Setting
-999.9 to 999.9% 100.0%
H3-04
Terminal A1 Bias Setting
-999.9 to 999.9% 0.0%
100%
-100%
5 V
10 V
-5 V -10 V
E1-04
E1-04
H3-01 = 0 H3-01 = 1
0 V
10 V 5 V
0 V
Gain = 200% Gain = 200%
100%
Frequecny
reference
Bias = 0%
E1-04
Gain = -200%