Appendix-4 Error Messages
Appendix
−
10
Builder
Appendixes
Message
Solution
N
No. of items for vertical (Line) is out
of range. Set from 1 to 40 including
item name.
The number of vertical items in a table can be
set from 1 to 40. Reset the number of vertical
items to a value within this range.
Number of function objects inside a
table exceeds the maximum limit
(256).
Reduce [Horizontal] or [Vertical] settings of
[No. of Items] in the [Table Setting] dialog
box so that the number of functional objects
that can be created in the table is limited to
256.
Number of characters are
exceeding the limit. Set within x
characters.
Specify within x characters.
O
Operation failed.
Check if the specified category or file is being
used by another project and try again. If not,
then the data may be corrupted.
P
Please enter an integer between xx
and xx.
Enter an integer within the range.
Project name is not set.
Specify the project file name that is to be used
for the process.
Correctly specify an existing file name in the
project maintenance.
Project of the same name exists. Can
not create new project.
Specify or create another folder then save the
project file.
Please enter an integer.
Enter an integer, starting with 0.
R
Restore source data does not exist.
Check the data.
Check if the restore data is specified
correct.
S
Screen is not open.
Select [Whole Project] for the [Check What]
in the [Validation] dialog box and try again,
or open the screen you want to check and
try again.
Setting is too short.
Re-enter the information. The setting must
be characters or more.
Select an object that has not yet been
selected.
In the Device layout box, enter the address
for the object.
Setting is incomplete.
Re-enter the information.
Sheet page No. is out of range. Set
a number from 0 to 9.
Reset the sheet page number between 0
and 9.
Specify the file which file name is
within 12 characters (8+3 format).
When specifying a file in the property
setting dialog box such as when selecting a
list, set the file within 12 characters (8+3
format).
Start address is larger than the
end address.
Set a number for the [Start Address] field
so that it is smaller than the number of the
[End Address] field.
