7-6 Setting Cyclic Communications Range
7 - 11
Builder
Chapter 7 Run Parameter Setting
2. Display the [Device set] box.
Number Item
Contents
1) Layout
points
Select a point to be used for cyclic communications.
If using words, select a point with 1 to 32 bits in a word.
If using bits, select a point with 16 to 512 bits. For bits, enter the
values as a multiple of 16.
2)
Register
Select CB or CW as the classification of the shared memory in
which files will be read/write to and from the MP2500 register.
3)
Start No.
Select the leading bit of the address for the shared memory, in
which files will be read/write to and from the MP2500 register.
If CB is selected as the register, enter the values as a multiple of
16.
4)
End No.
Displays the last bit of the address, which is used to read/write
files to and from the MP2500 register.
5)
Target no.
If using the MP2500 register in slot 1, select 1. if using slot 2,
select 2.
6)
Register
Select CB or CW as (the classification of the shared memory in
which files will be read/write to and from the MP2500 register.
7)
Start No.
Select the leading bit of the address of the register, in which files
will be read/write to and from the shared memory.
For bit addresses, a bit number can only be set to zero (0).
8)
End No.
Displays the last bit of the address, which is used to read/write
files to and from the shared memory.
9)
Delete
Delete the setting in the selected line.
3. After completing the layout settings for the device, click OK button.
