YASKAWA iQpump1000, Быстрый старт

Страница: 6 / 356

Step
5
Changing Parameters and
Monitoring the iQpump
This step shows how to access and modify an iQpump parameter
as well as how to monitor iQpump signals such as output
frequency and motor current.
Make sure all protective covers have been re-attached and power
is turned on.
DO NOT RUN THE MOTOR.
Press two times until the digital operator shows the parameter menu.
Select Digit
Access Parameter Menu and Change Parameter Value
Monitor Motor Frequency and Motor Current
Please refer to the iQpump Quick Start Manual, (Document No.
TOEP YAIP 1W 01) on how to access other drive monitors.
2X
Inc./Dec. Selection Inc./Dec. Selection Go to Next Digit
Switch to Edit Mode Save New Value Modify Value
iQpump Digital Operator power-up state
Output Frequency and Transducer Feedback can be monitored
simultaneously.
Hold button for 3 sec. to go back to the main menu.
2X
Use and to select monitor signals.
Press simultaneously shows the monitor menu.
Use to select monitor.
Press to access monitor menu.
Step
6
Application Setup
This step shows how to configure the iQpump for a dedicated pump
application.
Make sure all protective covers have been re-attached and power is
turned on.
DO NOT RUN THE MOTOR.
Available iQpump Application Macro’s:
•
6008 Constant Pressure Mode (PSI)
•
6009 Pump Down Level Mode (Ft)
•
6010 Geothermal Mode
•
6011 VTC Pressure Control Mode
•
7770 General Purpose Mode
Press two times until the digital operator shows the parameter menu.
Select Digit
Select Application
2X
Inc./Dec. Selection Select Application Switch to Edit Mode
Press to select.
Hold button for 3 sec. to go back to the main menu.
2X
Enter Application Parameters
3X
Select Parameter.
Switch to Edit Mode Save New Value Modify Value
Hold button for 3 sec. to go back to the main menu.
Go Back to Main Menu
Default
The factory default is setup for
constant pressure PSI, only
change if application different.
6 YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide