YASKAWA HV600, Установка и запуск

Страница: 222 / 310

7.11 o: Keypad-Related Settings
222 YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
◆
o2: Keypad Operation
No.
(Hex.)
Name Description
Default
(Range)
o2-02
(0506)
OFF Key Function Selection
Sets the function to use on the keypad to stop the drive when the Run command source for
the drive is REMOTE (external) and not assigned to the keypad.
0 : Disabled
1 : Enabled
1
(0, 1)
o2-03
(0507)
User Parameter Default
Value Sets the function to keep the settings of changed parameters as user parameter defaults to use during
initialization.
0 : No change
1 : Set defaults
2 : Clear all
0
(0 - 2)
o2-04
(0508)
Drive Model (KVA)
Selection Sets the Drive Model code. Set this parameter after you replace the control board. Determined by the drive
(-)
o2-05
(0509)
Home Mode Freq Ref Entry
Mode
Sets the function that makes it necessary to push to use the keypad to change the frequency
reference value while in Drive Mode.
0 : ENTER Key Required
1 : Immediate / MOP-style
0
(0, 1)
o2-06
(050A)
Keypad Disconnect
Detection Sets the function that stops the drive if you disconnect the keypad connection cable from the drive or
if you damage the cable while the keypad is the Run command source.
0 : Disabled
1 : Enabled
1
(0, 1)
o2-09
(050D)
Reserved - -
o2-19
(061F)
Parameter Write during Uv Enables and disables the function to change parameter settings during a Uv [DC Bus Undervoltage]
condition.
0 : Disabled
1 : Enabled
0
(0, 1)
o2-24
(11FE)
LED Light Function
Selection Sets the function to show the LED status rings and keypad LED lamps.
Note:
When you use A1-03 [Initialize Parameters] to initialize the drive, the drive will not reset this
parameter.
0 : Enable Status Ring & Keypad LED
1 : LED Status Ring Disable
2 : Keypad LED Light Disable
0
(0 - 2)
o2-27
(1565)
bCE Detection Selection Sets drive operation if the Bluetooth device is disconnected when you operate the drive in Bluetooth
Mode.
0 : Ramp to Stop
1 : Coast to Stop
2 : Fast Stop (Use C1-09 )
3 : Alarm Only
4 : No Alarm Display
3
(0 - 4)
◆
o3: Copy Keypad Function
No.
(Hex.)
Name Description
Default
(Range)
o3-01
(0515)
Copy Keypad Function
Selection Sets the function that saves and copies drive parameters to a different drive with the keypad.
0 : Copy Select
1 : Backup (drive → keypad)
2 : Restore (keypad → drive)
3 : Verify (check for mismatch)
4 : Erase (backup data of keypad)
0
(0 - 4)
o3-02
(0516)
Copy Allowed Selection Sets the copy function when o3-01 = 1 [Copy Keypad Function Selection = Backup (drive →
keypad)] .
0 : Disabled
1 : Enabled
0
(0, 1)