Yamaha YP125R, Руководство по обслуживанию

Страница: 115 / 498

CABLE ROUTING (YP250R)
2-84
1. Meter assembly
2. ECU (engine control unit)
3. Seat lock cable
4. Immobilizer unit coupler
5. Throttle cables
6. Wire harness
7. Sidestand switch lead
8. Rear brake hose
9. Front brake hose
10. Left front turn signal light lead
11. Rectifier/regulator
12. Starter motor lead
13. Headlight coupler
14. Air temperature sensor lead
15. Immobilizer unit lead
16. Main switch lead
17. Connector cover
A. Route the sidestand switch lead to the outside of
the rear brake pipe.
B. Route the sidestand switch lead to the inside of the
frame.
C. Route the sidestand switch lead to the outside of
the frame.
D. Position the connector cover as shown in the
illustration.
E. Forward
F. Fasten the wire harness at the white tape with the
holder.
G. Point the end of the plastic locking tie to the right,
and then cut off the excess end of the tie to 0
–
5
mm (0
–
0.20 in).
H. Point the end of the plastic locking tie forward.
I.
Point the end of the plastic locking tie to the left,
and then cut off the excess end of the tie to 0
–
5
mm (0
–
0.20 in).
J. Install the air temperature sensor so that there is
some slack in the air temperature sensor lead.