Yamaha Electone F-25, Руководство пользователя

Страница: 71 / 122

Operation
65
4. Tighten the air vent screw by turning it
clockwise.
5. Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to “
” (off).
EMU27865
Trimming outboard motor
WARNING
EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
EMU38881
Adjusting trim angle for manual tilt
models
WARNING
EWM00401

Stop the engine before adjusting the
trim angle.

Use care to avoid being pinched when
removing or installing the rod.

Use caution when trying a trim position
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
1. Stop the engine.
2. Tilt the outboard motor up and remove
the trim rod by pressing clip.
1. Air vent screw
1
ZMU07444
1. Trim operating angle
6BP-9-3B-1E0.book 65 ページ ２０１５年１１月１６日 月曜日 午後５時５７分