Yamaha Electone F-25, Руководство пользователя

Страница: 87 / 122

Maintenance
81
will leak out of the connector instead
of cooling the engine, which can
cause serious overheating. Be sure
the connector is tightened securely
on the fitting after flushing the en-
gine.
[ECM00542]
TIP:

When flushing the engine with the boat in
the water, tilting up the outboard motor un-
til it is completely out of the water will
achieve better results.

For cooling system flushing instructions,
see page 77.
EMU44342
Cleaning the outboard motor
When cleaning the outboard motor, the top
cowling must be installed.
1. Wash the exterior of the outboard motor
using fresh water.
NOTICE: Do not
spray water into the air intake.
[ECM01841]
2. Drain the cooling water completely out of
the outboard motor. Clean the body thor-
oughly.
EMU28463
Checking painted surface of
outboard motor
Check the outboard motor for scratches,
nicks, or flaking paint. Areas with damaged
paint are more likely to corrode. If necessary,
clean and paint the areas. Touch-up paint is
available from your Yamaha dealer.
EMU2848C
Periodic maintenance
WARNING
EWM01872
These procedures require mechanical
skills, tools, and supplies. If you do not
have the proper skills, tools, or supplies
to perform a maintenance procedure,
have a Yamaha dealer or other qualified
mechanic do the work.
The procedures involve disassembling
the motor and exposing dangerous parts.
To reduce the risk of injury from moving,
hot, or electrical parts:

Turn off the engine and keep the key(s)
and engine shut-off cord (lanyard) with
you when you perform maintenance un-
less otherwise specified.

The power trim and tilt switches oper-
ate even when the ignition key is off.
Keep people away from the switches
whenever working around the motor.
When the motor is tilted, keep away
from the area under it or between it and
the clamp bracket. Be sure no one is in
this area before operating the power
trim and tilt mechanism.

Allow the engine to cool before han-
dling hot parts or fluids.

Always completely reassemble the mo-
tor before operation.
Maintenance, replacement, or repair of
the emission control devices and sys-
tems may be performed by any marine
engine repair establishment or individual.
All warranty repairs, however, including
those to the emission control system,
must be performed by an authorized
Yamaha marine dealership.
1. Air intake
1
ZMU07873
6BP-9-3B-1E0.book 81 ページ ２０１５年１１月１６日 月曜日 午後５時５７分