K021 Instructions v1.0
Bag G
Page 45
ASSEMBLE ARMS TO THE BUGGY
G6)
Place the two brass bushings (6142) in the rear of the chassis, one on each side
of the transmission box. Some Team drivers put a small drop of Shoe Goo in the
chassis to hold the bushings in.
G8)
The X – 6 Squared is supplied with two toe-in bars (3211), 3 degree and 4
degree. Consult the Tuning Section and Set-Up Sheet to determine which bar
you will use. Here we are using the 4 degree bar. Team drivers pre-tap the two
vertical holes in the bar. Place the two Lunsford Ti hinge pins (6141) in the toe-in
bar. Again, consult the Tuning Section and Set-Up sheet to determine arm
spacing. Here we have .060” (long arrow) behind the arm and .030” (short
arrow) in front. Place one .060” shim on each hinge pin.
G9)
Place the control arms on the hinge pins. The round part of the bar where the
pins are should be down. The shock mounting holes are toward the rear of the
arms. Now put a .030” shim on each hinge pin ahead of the arm.
