K021 Instructions v1.0
Bag B
Page 13
B4)
Now put the spring over the shims.
B5)
Place the large washer over the metal servo saver bolt. Screw the servo saver
bolt down into the servo saver assembly. Be careful so the washer and bolt
assembly fits properly over the spring. The hex on the bolt is 9mm, although a
3/8” wrench will get the job done. Don’t be a gorilla here -- it’s easy to strip the
threads out of the lower bellcrank. You want the bolt snug on the bellcrank, but
not overtightened. More tension on the bolt does “tighten” the saver, once it
touches the saver that’s it.
B6)
Install a 3/16” ball stud (6170) in the end of the upper servo saver bellcrank.
