K021 Instructions v1.0
Bag I
Page 67
I12)
If you are using Lipo, install the ESC (not included) using double-sided tape in
the center of the chassis just ahead of the battery, and the receiver in one of the
side bays. With NiMh, the ESC and receiver will each go in one side bay. There
are two antenna mounts, so you can use the receiver on either side. A personal
transponder fits nicely on top of the servo, or in one of the side bays. The layout
pictured here is Paul Sinclair’s car, showing an SMC 4100 battery, Speed
Passion GT 2.0 Speedo, Competition 3.0 motor, a # DDP 023 Transmission
Brace, and a fan mount made out of some extra lexan.
THE BEAUTIFUL BODY
I13)
We’ve included some pretty awesome 2-piece window masks to make it easier to
have a classy-looking paint job. They do take a little extra care to install. The
first time we tried it – just trying to peel off the mask and stick it to the body – we
messed it up. After several tries, we found this process best: First, clean the
inside of the body (8021) with warm water and a gentle detergent. Cut each of
the window mask pieces out by trimming close to the mask. No need be super-
close, like a decal, just remove the excess. Then, carefully peel the opaque,
white, stiffer backing off, leaving the window masks stuck on the more
translucent, low-tack backing tape.
