K021 Instructions v1.0
Bag H
Page
55
BAG H
REAR TOWER, SHOCKS, TURNBUCKLES
TOWER
H1)
Check the Tuning Section and Set-Up Sheet
to determine if your wing will mount high or
low. There are two sets of holes in the tower
(3313) for the wing mounts (3500). Here we
have used the lower set of holes. Use four 4-
40 X 1/2” cap head screws (6002). Team
drivers pre-tap the wing mounts, but do NOT
tap more than 1/4” into the mounts. Also, do
NOT use longer bolts. The holes in the
mounts are not very deep.
TEAM TIP: Team drivers often cut off the pip
where the wing attaches to the mount,
grinding it flat. Then they drill a hole down
into the mount and attach the wing with a
black X Factory # 6452 wheel washer and a
flat head screw.
H2)
Install the tower with wing mounts
to the rear, using four 4-40 X 1/2”
cap head screws (6002). In a
few bulkheads, these screws
have stripped when over-
tightened, so keep the gorilla in
his cage. Poor guy – we never
let him out to play!
