K021 Instructions v1.0
Bag A
Page 10
BULKHEAD ASSEMBLY
A12) Install another one of those
2-56 X 1/8” button head
screws into the rear of each
control arm where the inner
hinge pin goes. Yes, do this
now. Just snug the screw
down to the arm.
A13) Remove the bulkhead (ASC 9563) and bag with two inner hinge pins from
Bag A. Place the bulkhead right side up on the bench. The “flat” side with
the recessed holes is the top. Place the right arm on the right side of the
bulkhead and slide the hinge pin through the front of the arm, the
bulkhead, and into the back of the arm until the pin just touches the little
button head screw. Don’t push the little screw out! The pin will protrude
from the front of the arm.
A14) Repeat for the left arm.
