K021 Instructions v1.0
Bag A
Page 7
A5)
Remove the 30° caster blocks (ASC 9593), two king pins (the shortest
ones), two 2-56 X 1/8” button head screws (6053), two 3/16“ ball studs
(6170), and four Dirtz Dialed Partz .030” shims from Bag A. Check the
set-up sheet and Tuning Section to determine which hole to use for your
ball stud. Here we have used the A hole (inside) for the ball stud. When
on the car, the ball stud land is to the rear of the caster block. Install a
3/16” ball stud from the front in each caster block.
A6)
Check the set-up sheet and Tuning Section to determine where you will
shim your steering blocks. Here the steering block is in the lowest position
with both shims at the top. Put the left steering block into the left caster
block and slide the king pin up from the bottom. As the pin emerges from
the top of the steering block, add two Dirtz Dialed Partz .030” shims, then
slide the pin the rest of the way into the top of the caster block.
