K021 Instructions v1.0
Bag E
Page
32
BAG E
TRANSMISSION INSTALLATION
PREPARATION
E1)
Install four ½” threaded inserts (6300 -- the long ones) in the rear of the chassis
from the bottom. Make sure the hex of each insert seats properly in the chassis.
You may have to tap lightly to fully seat the inserts.
Some inserts are more difficult to seat. In those cases, Team drivers use one of
the flat washers and one of the 5/8” cap head bolts from Bag E. Place the bolt
and washer down from the top through the hole in the chassis and thread it into
the top of the insert. Hold the insert’s hex with a pliers and screw in the bolt to
draw the insert up into the chassis. Then remove the bolt and washer.
The inserts should remain in place through the transmission install, and it’s
easiest to put them in now. The rearmost holes in the chassis will be used later –
they do not have hexes for the inserts.
