Xerox WorkCentre 450c/450cp Service Manual
Page 4-37
REP 4.1.7: Scanner motor and
gear assembly
Parts List: 1.1
1.
Perform the following:
a.
REP 1.1: WorkCentre Cover on page 4-3
2.
Disconnect the scanner motor wiring harness
from main board connector CN5.
3.
To remove the scanner motor only, remove
the 2 screws that secure the motor to its
mounting bracket (Figure 4-46).
Figure 4-46 Scanner motor
4.
To remove the scanner motor and gear
assembly, remove the two screws that secure
this assembly to the scanner chassis (Figure
4-46)
To remove the scanner motor only,
remove these screws
To remove the scanner motor and
gear assembly, remove these screws
www.printcopy.info
www.printcopy.info
