HOST INTERFACE PROCESSOR (HIP) MESSAGES
HP7100
Can not change HOSTs while jobs are Pending or Active.
Hosts cannot change until all jobs are completed.
Action
1. Wait until active and pending jobs are completed.
2. Enter the appropriate HIP HOST command to change hosts.
HP8100
HIP dynamic MEMORY ALLOCATION FAILURE: Reload.
HIP does not have enough memory to continue.
Action
1. Enter the HIP END command.
2. Reload HIP or reboot the system.
HP8250
Fatal protocol violation detected.
Channel commands violating the higher level software protocols
were used to communicate between HIP and the XPAF host. The
host will be advised to restart communication with the printer.
No data should be lost in this process.
Action
None.
HP9200
Interface failure: unable to receive data.
The attempt to go online or offline failed due to a physical
channel or network problem.
Action
1. Reenter the HIP ONLINE command.
2. If the error continues, contact your service representative.
HP9210
Interface failure: Failed to go offline.
HIP is unable to go offline due to a channel error that occurred
while it was trying to notify the XPAF host.
Action
None.
HP9400
HOSTCLR not received. See HOST for reason.
You entered the HIP DIAGNOSTIC command for interactive
diagnostics. The system failed Test 1, and the HOSTCLR control
line was not verified.
Action
1. Inspect the 871-CM display at the host referred to in the
message to learn the nature of the failure.
2. Wait until the diagnostic test is terminated or completed.
3. Contact your service representative and provide the
information from the display.
HP9410
Data to HOST transfer error. See HOST for reason.
A file transmission to the DMR host was aborted. This message
may appear during recovery if the printer crashed while a HIP
SEND command to the DMR host was in progress.
Action
Contact your service representative and provide the information
from the display.
7-14
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
