OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
OS9104
Disk error processing Interpress job errors (RTXFIL.SYS)
Action
1. If RTXFIL.SYS does not exist, perform DSR restore and sysgen
if you are authorized to do so, or contact your service
representative to recover RTXFIL.SYS.
2. If RTXFIL.SYS does exist, perform these actions:
A. Rename the RTXFIL.SYS file, giving it a name such as
BADnnn.TMP.
B. Restore the file through a resysgen if you are authorized
to do so, or contact your service representative.
C. Resend the job.
D. Contact your service representative to log the bad sector
and delete the file you named BADnnn.TMP.
OS9200
Hardware error-input drive. Call for service.
A fatal error other than a read error occurred. Due to the failure
mode, the system cannot recover the data block.
Action
1. Perform one of the following actions:
•
If the data loss is acceptable, press <CON> to resume
printing.
•
If the data loss is unacceptable, enter the ABORT job
command to cancel the job.
2. Resend the job.
3. If the problem continues, contact your service representative
and report SAN (Software Analysis Number) 20.00.02.
OS9210
Parity error on input medium
This message appears if either of the following conditions exists:
•
The system discovered a parity error in the data from the
magnetic tape.
•
The system is trying to read a 6250 bpi tape on 1600 bpi
magnetic tape drive.
Action
Perform one of the following actions:
•
Check the density of the tape. Mount a tape of the correct
density for the drive and restart the job.
•
Enter the CONTINUE command to try to resume the job.
The message does not reappear if the failure was an
intermittent error. However, the failure may recur or new
failures may occur when trying to resume the job.
•
Enter the ABORT job-id command to cancel the job.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
9-109
