DOCUPRINT 96/4635/180 IPS MESSAGES
XEROX DOCUPRINT IPS MESSAGES GUIDE
2-37
08-227
14” transfer assist blade failure.
A change in the state of the transfer assist blade sensor was not
detected. This error is logged by the system.
Action
No action is required.
08-302
Reg servo controlled failed.
The registration servo controller failed to execute an initialize
command.
Action
Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
08-310
Unable to communicate with reg servo.
The control logic cannot communicate with the PHN registration
servo board.
Action
Open the right door of the printer, clear areas 2 and 4, close the door,
and retry the operation. (Refer to the
Xerox DocuPrint 96/4635/180
IPS Troubleshooting Guide
for the procedure.)
08-312
Reg servo failed turn around test.
The PHN registration servo board turnaround diagnostic test failed.
Action
Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
08-901
Tray 1 stock does not match UI.
The paper stock loaded in input tray 1 does not match the paper
stock specified for paper tray 1 at the user interface.
Action
Replace the paper in input tray 1 with the correct paper stock, or
change the input configuration for paper tray 1. (Refer to the
Xerox
DocuPrint 96/4635/180 IPS Guide to Configuring and Managing the
System
for input configuration procedures.)
08-902
Tray 2 stock does not match UI.
The paper stock loaded in input tray 2 does not match the paper
stock specified for paper tray 2 at the user interface.
Action
Replace the paper in input tray 2 with the correct paper stock, or
change the input configuration for paper tray 2. (Refer to the
Xerox
DocuPrint 96/4635/180 IPS Guide to Configuring and Managing the
System
for the procedure.)
