DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
XEROX DOCUPRINT IPS MESSAGES GUIDE
3-39
P194
Input power to polygon driver board out of range.
The polygon driver board + 15V, -15V, or the -5.2 V voltage is not
within the acceptable range.
Action
No action is required. If the error persists, contact your service
representative.
P195
Output power from polygon driver board out of range.
An error occurred in one or more motor driving signals.
Action
No action is required. If the error persists, contact your service
representative.
P196
Enable line to polygon motor fault.
The motor enable signal is not on, or the motor is off.
Action
No action is required. If the error persists, contact your service
representative.
P199
SOS scan board fault.
The SOS board was unavailable during a scan interval.
Action
No action is required. If the error persists, contact your service
representative.
P200
Enable line to laser fault.
An error occurred in the enable line to the laser.
Action
No action is required. If the error persists, contact your service
representative.
P201
Modulator fault.
The laser is turned off due to a modulator fault.
Action
Contact your service representative.
P202
Laser Tube or Laser power supply failed.
The laser tube or the power supply to the laser failed. You cannot use
the machine until this problem is repaired by your service
representative.
Action
Contact your service representative immediately.
P204
EOS scan board fault.
The EOS board was unavailable during a scan interval.
Action
No action is required. If the error persists, contact your service
representative.
