DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
XEROX DOCUPRINT IPS MESSAGES GUIDE
3-33
J176
Stacker offset fault.
The stacker did not offset the output as specified for the job. The
stacker mechanism may be defective.
Action
No action is required. If the error persists, contact your service
representative.
J185
Stacker elevator fails to reach new position.
After two attempts, the stacker elevator was not able to reach
another position.
Action
No action is required. If the error persists, contact your service
representative.
J188
Exposure level exceeded /- tolerance.
The laser exposure did not stabilize to the specified level after the
machine was turned on, or the exposure level exceeded the
acceptable range.
Action
No action is required. If the error persists, contact your service
representative.
J191
Pixel clock error or SOS/EOS scan lines missing.
A pixel clock output error occurred.
Action
No action is required. If the error persists, contact your service
representative.
J197
SOS/EOS not balanced.
The ROS intensity difference is not balanced.
Action
No action is required. If the error persists, contact your service
representative.
J198
Polygon motor assembly producing extra scan lines.
Extra scan pulses (EOS or SOS) occurred during the print job.
Action
No action is required. If the error persists, contact your service
representative.
J213
Generic Pixel board fault.
The voltage Controlled Oscillator (VCO) voltage is not within an
acceptable range. When this error occurs during imaging, the system
performs an ROS PURGE.
Action
No action is required. If the error persists, contact your service
representative.
