Alphabetical reference
Commands and Queries Reference
SHUT
defines the optional events that will cause a single, group or global
shutdown.
Syntax
SHUT
<int>
Parameters
the integer is a value in the range 0 to 7, derived
from summing the following event category
selections:
1 – errors reported by the Power Module (not
including error codes 7 and 8).
2 – sense warning.
4 – window warning.
Category System
Type:
Sequential
SHUT?
returns the current selection of non-fault events that will cause a
single, group or global shutdown. The returned value (in the range 0 to
7) is a sum of individual events categories selections (see SHUT
command above).
Syntax
SHUT?
Parameters none
Category System
Type:
Sequential
When the Power Supply is turned on or a full reset is performed, the
selection of non-fault events that will cause a single or global shutdown is
cleared.
SN?
return the Power Module’s Serial Number. The result is a six digit
number.
Syntax
SN?
<ch>
Parameters
the number of the channel to be queried.
Category System
Type:
Sequential
SRQS?
return the Power Modules Summary Register. The result is two
decimal numbers. Each bit of the reply represents a channel. A bit
value of “0” means that the Power Module has no enabled status
events. A bit value of “1” means that it has. The reply is a 16-bit value
with its high order byte sent first. The summary bits are cleared and
<rqs> re-calculated.
Syntax
SRQS?
Parameters none
Category Status
Type:
Sequential
60
XMP 2600 Programming Manual
rev. 1.1
