Wohler AMP1-16V-MD, Руководство пользователя

Страница: 45 / 142

8 2 1 6 9 7 : A M P1 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 3 Wo h l e r Te c h no lo g i e s , I n c . A l l r i g h t s r e s e r ved .
37
C h a p t e r 3 Audio and Metering
C o n fi g ur i n g t h e A u d i o O ut p u t s
as presets and recalled later. See Chapter 5 : Efficiency Enhancements on
page 51 .
Figure 3–1 Audio Routing Diagram
Surround Sound
If a studio or other monitoring environment contains a surround sound
system, it may be advantageous to connect the monitored sound from
the AMP1-16 Series monitor to this system. Up to eight pairs (16
channels) of AES outputs or four pairs (eight channels) of analog
outputs are available for this use. The front panel
Volume
,
Balance
,
and solo, and mute controls will then optionally affect the surround
sound. You can easily configure this in the
AES Output
and the
Analog Output Configuration Menus
as described below.
3G SDI Input 1
3G SDI Input 2
3G SDI Output
AES Inputs
Analog Outputs
AES Outputs
Monitor Amplifiers, Speakers, & Headphone Jack
8 De-embedded SDI Pairs
8 AES Pairs
5 Dolby Pairs
8 Monitor Mixer Pairs
Monitor Downmix Pair
Configuration Selection
Recall Preset 1
SDI Source 2
Monitor Menu 3
Screen Menu 4 Dolby
Preset Mgmt 5
Analog Out 6
7
AES Out
8
Dolby Configuration Menu
Decoder Src 1
Pro16 Mode 2
Dolby E Pgm 3
4
5
Bitstream Det 6
7
8
Monitor Mixer Config Menu
Sel Channel 1
Channel Trim 2
Spkr Assign 3
Mute Spkrs 4
Audio Delay 5
Channel Src 6
7
Phase LED 8
AES Output Menu
AES Output 1
Affect S/M 2
Level Trim 3
AES Ch Pair 4
5
6
Affect Vol
7 Chan Output
8 Mute w/ HP
Analog Output Menu
Analog Out 1
Affect S/M 2
Level Trim 3
Alg Ch Pair 4
5
6
Affect Vol
7 Chan Output
8 Mute w/ HP
Unit Info
Hardware Configuration
Menu
Screen Saver 1
2
Analog Ref 3
AES Term 4
System Reset 5
Scrn Bright 6
7
AES Term All 8
USO
RESTRITO