Wohler AMP1-16V-MD, Руководство пользователя

Страница: 125 / 142

8 2 1 6 9 7 : A M P1 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 3 Wo h l e r Te c h no lo g i e s , I n c . A l l r i g h t s r e s e r ved .
117
A p p e nd i x 9 Establishing Connectivity
Co n ne c t i n g D i re c t ly
Connecting Directly
This set of instructions describes how to connect a Windows PC
directly to an AMP1-16V. Direct connections are not as easy to
accomplish as network connections. Therefore, these instructions
should only be used if the AMP1-16V does not have access to a LAN
(Local Area Network) with a DHCP server (Dynamic Host Control
Protocol – supplies IP information to devices on the LAN
automatically), or if a portable router with such a server in it is not
available.
For all direct connections, you will need a crossover cable rather than a
standard “patch” cable. A crossover cable has two wire pairs reversed
between one end and the other. They typically have a label that says
“Crossover,” since they are otherwise difficult to distinguish from
standard patch cables.
To connect directly, the unit must be capable of using AutoIP (see
requirements in next section) or compatible static IP addresses must be
used in both the computer and the unit. See
Setting a Static Ethernet
Configuration on page 115 to set the unit, and refer to either Setting a
Static IP in a Windows XP Computer on page 121 or Setting a Static IP
in a Windows 7 Computer on page 126 for setting a static IP in your
computer.
Using AutoIP
If your AMP1-16V has Version 3.10 or later installed, it has AutoIP
capability. Windows XP and Windows 7 computers also have this
capability, which allows the computer and the unit to auto-negotiate
their IP information, and begin communicating over the crossover
cable. The unit must be set for DCHP (Refer to
Launching the Setup
Tool on page 114 ) and it must have Application Version 3.10 or later. If
either one of these is not true, AutoIP will not be available, and you
must use one of the connection methods mentioned in
Connectivity
Options on page 114 .
1. If the computer is running, shut it down.
2. If you wrote down a static IP in the section above, you need to set
the AMP1-16V for DHCP (using the
Set for DHCP
button in the
Ethernet Setup Screen
) and allow the AMP2-16V to restart.
USO
RESTRITO