page A – 74
WheatNet-IP BLADE 3
/ Jan 2016
A P P E N D I C E S
Menus
Operation of the IP-MTR64 Meters GUI is done through the use of menus, both drop
down from the main menu bar, and popups that are activated by right-clicking at specified
areas of the GUI. In this section we describe the various menu items, both those that have
been described throughout the manual and those that haven’t yet been mentioned.
View
The
View
menu contains a few items that are necessary for basic program configuration
and operation. The available items are:
Full Screen
– Switches the program to a full screen view that eliminates both the
status bar and the title bar from the display and in fact also hides the Windows task
bar. While in full screen mode you can right-click in the area of any meter cell and
select
Exit Full Screen
from the popup to revert to a normal view. You can also use
the F11 key to toggle in and out of full screen mode.
About...
– Brings up a typical About dialog box to show you the program version.
Exit
– Use to close the application.
Layout
The
Layout
menu contains items that are used to adjust the layout of meter cells and
the analysis window. The available items are:
New
– Use to create a new meter layout.
Open...
– Use to open a previously saved layout file.
Save
– Use to save the current meter layout to the last opened layout file.
Save As...
– Use to save the current meter layout to a new file.
Configure...
– Use to edit the current meter layout.
WheatNet-IP System
The
WheatNet‑IP System
menu contains items used to acquire needed information
from the WheatNet-IP system. The available items are:
Open...
– Use to open a previously saved system information file containing a list of
sources and destinations that the program used when system resources were discovered
via a system scan. This is handy when you are going to be setting up a meter layout
on a computer that is not currently connected to the system.
Save As
– Use to save the current source and destination system information to a file
for reference at a later time.
System Scan...
– Begins the process of discovering the available source and destination
signals in the WheatNet-IP system.
View Info...
– Shows the list of source and destination signals known to the program.
Setup
The
Setup
menu contains items used to configure program options. The available
items are:
Network...
– Use to set the network interface and the Peripheral Devices port.
Содержание WheatNet-IP BLADE3
