BA DT08 SL EN – Edition 1.0 * dt08b330.fm
3-7
Operation
Manual starter
Caution!
Do not allow starter handle
F
to whiplash against the engine.
☞
Carefully move back handle
F
to avoid damage to the starter.
☞
Slightly pull starter handle
F
until you can feel a resistance, then firmly pull the handle.
Electric starter
☞
Turn starter
G
to position
H
and keep it in this position until the engine starts.
➥
Move the switch back to position
I
after the engine has started.
Notice!
Do not actuate the electric starter for more than 5 seconds. If the engine does not
start, release the ignition switch and wait 10 seconds before actuating the starter
again.
Circuit-breaker (for electric starter):
The circuit-breaker protects the battery’s load circuit. The circuit-breaker is triggered in
case of a short circuit or if the battery’s terminals are inverted.
The green indicator in the circuit-breaker is ejected to indicate that the circuit-breaker has
been triggered. In this case find out the cause for the error or contact your Wacker Neuson
workshop before resetting the circuit-breaker.
☞
Press circuit-breaker button
J
back in to reset.
Starting at low temperatures
When the engine runs smoothly (increased engine speed):
Notice!
In general, a battery delivers less energy in cold conditions. Therefore ensure that
the battery is always well charged.
When the engine has started
☞
Gradually push choke lever
A
to position
B
☞
Let the engine warm up
➥
After the engine has reached its operating temperature, move choke lever
A
fully to
the right
At cold temperatures:
☞
Increase the engine speed slowly
☞
Do not run the engine at full load until it has reached its operating temperature
Fig. 26: Starter handle
F
Fig. 27: Electric starter
G
H
I
J
K
Fig. 28: Choke lever
A
B
