VITEK Industrial Video Products – Transcendent Series NVRs
131
Select the camera and then enable audio device.
Audio In Device: Please select it according to the actual device configuration.
Speaker (built-in): Please select its function as needed.
LOUT: External audio output device, please select its function as needed.
Audio Input Encode: G711A/G711U
Local Audio Alarm
Set the audio alarm of local NVR.
In this interface, you can set the volume of local audio. Click “Add” to upload the audio file.
Choose the uploaded audio file and then click “Listen” to listen to it; click “Delete” to delete this
file.
VITEK Industrial Video Products – Transcendent Series NVRs
132
11.5.7 Light
Click Start
à
Settings
à
Alarm
à
Event Notification
à
Light to go to the interface as shown below.
In this interface, you can set the light flashing time and frequency when an alarm is triggered.
11.5.8 Alarm Server
Go to Alarm
à
Alarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select protocol.
If “Send Heartbeat” is enabled, set the interval times. After that, test the effectiveness of the
alarm server. Having tested successfully, please click “Apply”. When an alarm occurs, the device
will transfer the alarm event to the alarm server. If an alarm server is not needed, there is no need
to configure this section.
11.6 Manual Alarm
Click
on the tool bar at the bottom of the live preview interface to pop up a window. Click
“Trigger” to start alarm. Click “Clear” to stop alarm.
11.7 View Alarm Status
Click Start
à
Settings
à
Alarm
à
Alarm Status or click
on the tool bar at the bottom of the
Содержание VT-TNR1646PF
Страница 185: ...NOTES ...
