VoIP Service
230
SBX IP 320 Features & Operation Guide
Normal/Fast mode for H.323
H.323 endpoints may establish media channels in a call by using either the procedures defined
in Recommendation H.245 or the "Fast Connect" procedure described below. The Fast Connect
procedure allows the endpoints to establish a basic point-to-point call with as few as one
round-trip message exchange, enabling immediate media stream delivery upon call connection.
The calling endpoint initiates the Fast Connect procedure by sending a SETUP message
containing the fastStart element to the called endpoint. The fastStart element consists of a
sequence of OpenLogicalChannel structures describing media channels which the calling
endpoint proposes to send and receive, including all of the parameters necessary to immediately
open and begin transferring media on the channels.
Admin Programming
•
Normal/Fast Mode (PGM 340 - F 18)
TOS for H.323
In the IP Datagram, 8 bits are reserved to the Service type. These bits can be further broken into
5 subfields given below.
The 3 precedence bits specify the datagram precedence varying from 0 to 7. This allows the
senders to indicate the importance of each datagram. The TOS provides a mechanism that can
allow control information precedence over data. The other 3 bits represent the following:
D - requests low delay
T - requests high throughput
R - requests high reliability
The precedence bits (bits - 0,1,2) are significant in having an effect on load. So, we vary these
bits and try to monitor the changes in the RTT (Round Trip Time) for varying loads.
At low loads, the traffic is not significant enough for the TOS to have any effect on the ping as
the packets will get through anyway. Similarly at high loads, the TOS will not have an effect on
the ping statistics but in this case there's too much traffic & there will be a significant amount
of packet loss & elongated round trip times irrespective of the precedence set. Somewhere in
between these two extremes we expect to see a window where the TOS actually has an effect
on the RTT/packet loss (high RTT/Packet loss at TOS=0 & low RTT/Packet loss at TOS=224).
0
1
2
3
4
5
6
7
PRECEDENCE
D
T
R
UNUSED
Содержание SBX IP 320
Страница 1: ...Features Operation Guide SBX IP 320 ...
Страница 4: ......
Страница 242: ...VoIP Service 232 SBX IP 320 Features Operation Guide ...
Страница 248: ...Index IND 6 SBX IP 320 Features Operation Guide ...