VERDER CARBOLITE GERO 3016, Инструкции по установке, эксплуатации и обслуживанию

Страница: 33 / 56

l
Lo
- Minimum output applied.
l
R2G
- Relative channel 2 gain test is running.
l
Pd
- The autotuner is trying to control to the setpoint
and is examining the response.
l
AnLs
- The autotuner is calculating the new tuning para-
meters.
STG.T
Time Elapsed in
Stage
Displays the time elapsed during the current autotune
stage. If an autotune stage lasts longer than 2 hours a
timeout will occur and the autotune will be aborted.
PiD
Sublist:
SET
Active Tune Set
Displays the PID terms set being used:
l
Set 1
l
Set 2
BND.1
Tune Set
Switching Point 1
Used to set the level at which PID set 1 changes to PID set
2.
Note: Also adjustable at Operator Level 3.
gs.hys
Switching
Hysteresis
Used to set the hysteresis level around when the controller
Note: Also adjustable at Operator Level 3.
OP.HI
Output High
Limit
Used to set the gain scheduled upper limit for PID set 1.
Note: Also adjustable at Operator Level 3.
OP.HI2
Output High
Limit 2
Used to set the gain scheduled upper limit for PID set 2.
Note: Also adjustable at Operator Level 3.
OP
Sublist:
OUT.HI
Output High
Limit
Used to set the maximum output power (%) delivered by
the heating elements of the product.
Depending on the design of the product and the voltage of
the intended power supply, the Output High value may be
adjusted in order to protect the heating elements from
overloading and unnecessary wear.
Note: Also adjustable at Operator Level 3.
OUT.LO
Output Low Limit
Used to set the minimum output power (%) delivered by
the heating elements of the product.
OP.UP
Output Rate Up
Used to limit the rate at which the output from the PID
terms can increase (% per second).
33