VERDER CARBOLITE GERO 3016, Инструкции по установке, эксплуатации и обслуживанию

Страница: 18 / 56

(
P.seC
), °C per minute (
P.mIN
), or °C per hour (
P.HR
).
DWEL.U
Dwell Units
Used to define whether the dwell units are seconds (
SECS
),
minutes (
mINS
), or hours (
HRS
).
P.CYC
Program
Cycles
How many times the program is set to run. Setting the
value to "cont" will set the program to cycle continuously
until the operator manually intervenes.
P.END
Program End
Type
l
DweL
- maintain the temperature achieved by the pre-
vious segment until the user manually intervenes to
reset the program
l
Rset
- stop the program automatically and return to
basic controller mode
l
TRaK
- this parameter is not supported and should not
be used with any Carbolite Gero product.
Segment Setup
S.NUM
Segment
Number
Displays the segment number. A program can have up to
24 segments. Use the up and down buttons to select the
segment number that you wish to view/edit.
S.NAME
Segment
Name Displays the name of the segment. The first segment is
named
S1
by default.
S.TYPE
Segment
Type
Used to set the segment type (see below for further details
on segment types).
l
RAtE
l
tImE
l
dwEL
l
StEP
l
ENd
Note: When first setting up a program the segment type
is set to "End" by default. Changing the segment type
will enable additional parameters and allow the operator
to access and edit further segments within the program.
Segment
Type
Parameters Description / Use
RAtE
TSP
Used to define the Target Setpoint for that segment i.e.
the temperature (°C) that is to be reached at that point in
the program.
R.RATE
The amount of degrees (°C) the temperature should
increase per second/minute/hour (dependent on “Ramp
Units” parameter).
18