Urschel COMITROL 2100, Инструкция по эксплуатации

Страница: 9 / 166

A.7 Addendum
Manual Page Number Revision
Feeding Method
m
DANGER
Never place hands into the feed opening!
The feed area contains a rotating feed
screw and a rotating agitator which can
cause serious injury such as amputation!
IMPORTANT
Do not allow foreign material such as metal,
stone or wood to enter the feed area.
Parts will be damaged and the product
contaminated.
The feeding method affects the quality
and capacity of the finished product. A steady,
uniform flow of properly sized product from a
conveyor or similar feeding system yields the
best quality and greatest capacity. Dumping
large quantities of product into the feed
opening produces undesirable cuts and can
overload the motor, clog the feed opening, or
jam the cutting unit. Continuous overfeeding
or jamming will also cause premature damage
and failure of machine components.
The potentiometer dial (1) on the
electrical enclosure controls the speed of the
feed screw motor. To increase the feed rate,
turn the dial to the right. To reduce the feed
rate, turn the dial to the left. When the optimal
feed rate is found, look through the window
on the electrical enclosure door and note
the percentage displayed on the motor load
indicator (2) . This percentage can be used as
a reference for setting feed rates in the future.
The optimal feed rate may be at less than
100% of full motor load.
Except for an emergency, never start or
stop the machine when the cutting unit is full
of product. This puts a tremendous strain
on the motor, bearings and cutting parts.
In addition, product that is cut before the
machine has reached full operating speed
may be of such poor quality that it must be
discarded.
30 Operation, Feeding: The following replaces the information in the machine
manual.
1
2