Urschel COMITROL 2100, Инструкция по эксплуатации

Страница: 121 / 166

REASSEMBLY
1. Install seal and seal cover. Make sure
seal is properly oriented (tabs flush with
seal surface facing out). See Figure 30.
2. Install impeller. All mating surfaces
must be free from nicks or foreign mate-
rial. Install fasteners and tighten
securely.
3. Replace hub guard if removed.
4. Install cutting head and replace fas-
teners.
5. Check for clearance between cutting
head and impeller.
Release motor
brake and rotate impeller backwards
(counterclockwise) several times by
hand to make certain there is no metal-
to-metal contact (Figure 31).
WARNING: Keep fingers away from
cutting head! Do not pinch fingers between
cutting head and impeller. Cutting edges
are sharp and could cause injury.
6. Install feed screw and thrust bearing.
Align slot in drive shaft with pin in feed
screw.
7. Install feed adapter. Carefully slide
adapter over feed screw and position on
locating studs. Fasten in place with
clamp screws.
8. Install agitator and thrust bearing if
removed. Align slot in drive shaft with
pin in agitator. Install bearing retainer
with bearing.
9. Replace cutting enclosure.
43
MAINTENANCE
Cutting and Feed Assemblies
Figure 30 — Installing Seal
Figure 31 — Release Motor Brake. (1) Lever, in
“release” position
1