ULTRAFRYER F-P20-18, Руководство по эксплуатации

Страница: 36 / 60

30A168
e. EXIT MELT BUTTON - When this button is momentarily depressed, the melt cycle timing module in the
DTMR’s Default-To-Melt circuit will switch to the FULL-ON position allowing the Electronic Thermostat
to heat shortening to it’s PRE-SET temperature.
D. DTMR OPERATION - Prior to operating the gas fryer, ENSURE the Filter Tub Assembly is properly installed and
DOCKED to the fryer’s Bulkhead socket and the Temperature Control Access Door is closed, the fryer vat is filled with
shortening to the middle of the “E” in the word LEVEL of the shortening level mark on the rear wall of the vat; then:
1. Turn the Toggle ON/OFF Power Switch to the OFF Position.
2. Turn the MANUAL gas valve to the OFF position and wait
FIVE (5) minutes for any accumulated gas to disperse.
3. ENSURE the MAIN gas shut-off valve is in the ON posi-
tion, and that the EXHAUST FAN is ON.
4. Turn the MANUAL gas valve to the ON position.
ITEM ACTION DTMR CONDITION
1
ENSURE the drain valve is in the CLOSED
UP
position and that shortening is at the proper level;
then turn the Toggle ON/OFF switch to the ON posi-
tion.
A.
AMBER
power lamp will
LIGHT
.
B. BLUE READY TO START lamp will LIGHT.
CAUTION: PRIOR TO PROCEEDING TO STEP 2 VISUALLY CHECK THAT THE HEAT ELEMENT IS
COVERED WITH AT LEAST 2" (51 mm) OF SHORTENING.
2 Depress, then release the momentary START button.
A. RED STARTED lamp and AMBER MELT
MODE lamp will light.
B. BLUE READY TO START lamp will turn OFF.
C. The
MELT CYCLE TIMING MODULE
in the
Default-To-Melt electrical circuit will begin
cycling the fryer heat mechanism
ON for twelve
(12) seconds and OFF for 28 seconds to safely
heat the shortening.
CAUTION: PRIOR TO PROCEEDING TO STEP 3, VISUALLY CHECK THAT THE SHORTENING
COMPLETELY COVERS THE HEAT MECHANISM.
3
Depress, then release the momentary EXIT MELT
button.
A. AMBER MELT MODE lamp will turn OFF,
RED STARTED
lamp will remain lit.
B. The Melt Cycle Timing Module in the
Default-To-Melt circuit will switch to the FULL
ON position allowing the Electronic Thermostat
to heat shortening to its pre-set temperature.
4
When the fryer’s pre-set temperature has been
reached, initiate a cook cycle.
Page 32 of 56