TSI Instruments SIZER EEPS 3090, Руководство по эксплуатации и обслуживанию

Страница: 41 / 185

Quick Start 3-5
When the sample finishes, data for the sample is stored in the file, but the
windows remain open.
To stop data collection before the selected run length time is complete,
select
Run|Stop Data Collection or on the toolbar .
Communications Errors
If you get the following error message (Figure 3-5) when you try to start a
new sample, there is a communications problem between the computer and
instrument (i.e., the cable is not connected) or a connection is already open
to the instrument, such as another run, and are attempting to open another
connection.
Figure 3-5
Communications Error Dialog Box
Check the cable connection and close all files and then try to reconnect.
Note: Most computers have only two active communications ports, COM1
and COM2. COM1 is most likely available for the EEPS connection.
Run Properties
The Run Properties dialog box contains three tabs: Run Settings, Analog
Out, and Communications.
If this is the first time you have accessed the Properties dialog, you need to
set up the parameters before continuing. If you have set up the properties
before, verify they are correct before pressing
OK . The following
paragraphs describe the settings of the Properties dialog box.
The Run Settings Tab
Use the Run Settings tab to enter information about the run and control
variables for the run. Once the run settings are set, you can store them for
later use by selecting the
Save Settings to File... and Load Settings from
File... buttons.