TSI Instruments SIZER EEPS 3090, Руководство по эксплуатации и обслуживанию

Страница: 151 / 185

Serial Commands D-5
C o m m a n d S u m m a r y
The firmware commands are be divided into the following categories:

READ Commands

SET Commands

HELP Commands
READ commands are used to read parameters from the instrument (flow
rates, voltages, etc.). READ commands can be identified by a leading
"R".
SET commands set an internal parameter to the value(s) supplied with
the command. Supplied parameters are always delimited by a comma.
SET commands can be identified by a leading "S". The instrument will
reply to all s
et commands with the string “OK” <
CR > if the command
syntax is valid. Also, if no parameter is supplied, the command will return
the current set value.
HELP commands.
Type “HELP” in a HyperTerminal window or a similar
program and it will explain how to use it. The detailed command
descriptions shown below can be obtained using the help command.
The instrument will reply with a serial string of "ERROR", if a command
was not understood.
READ Commands
RDR,1 Read Data Record (unpolled binary)
RDR,2 Read Data Record (unpolled trigger)
RDR,3 Read Data Record (unpolled binary)
RDR,4 Read Data Record (unpolled text)
RSR Read Status Record
RPID Read PID Control Parameter
RFV Read Firmware Version
RF Read Flow
RAV Read Analyzer Voltage
RC Read Charger
RADC Read Analog Digital Converter
RT Read Temperature
RIE Read Instrument Error
RIS Read Instrument Status
RP Read Pressure
RSN Read Serial Number