TSI Instruments SIZER EEPS 3090, Руководство по эксплуатации и обслуживанию

Страница: 130 / 185

6-32 Model 3090/3090AK Engine Exhaust Particle Sizer
TM
Spectrometer
Table 6-3
Fatal Error Flags
Error
Code
Error Message Suggested Action
16 Column Voltage Section 1 Too Low
Contact TSI
17 Column Voltage Section 1 Too High
18 Column Voltage Section 2 Too Low
19 Column Voltage Section 2 Too High
20 Column Voltage Section 3 Too Low
21 Column Voltage Section 3 Too High
32 Absolute Pressure Too Low
33 Absolute Pressure Too High
37 Instrument Matrix Readback Error
38 ELM Covariance Readback Error
39 ELM Offset Readback Error
40 ELM Gain Readback Error
41 Missed DSP Interrupt
42 DSP Command Code Timeout Error
43 DSP Reset Timeout Error
44 COM1 Xmit Buffer Overflow Error
45 Flowmeter EEPROM Error

Check all connectors on main pc-board.
46 Serial Communication Error (Set by
Software)

If using a long cable, test with a standard length RS-
232 cable. If used in an electrically noisy environment,
remove instrument to a less noisy environment and try
again.
48 DSP Timing Error
Contact TSI
49 DSP Command Code Error
51 Electrometer Gain Error Contact TSI
52 Electrometer Chan Above Noise Limit

During instrument zeroing, the offset current and/or
RMS noise for one or more channels was very high.
Retake the zero with the instrument disconnected from
any other equipment, in a vibration-free area, or with
the filter provided in the accessory kit (1031252) on the
inlet. Clean the column or contact TSI.
53 DSP Instrument Matrix Error Contact TSI
55 DSP Data Not Valid
Contact TSI 56 DSP Checksum Error 1
57 DSP Checksum Error 2
58 Electrometer PCB 1 Error There is a 60-conductor ribbon cable between the column
and the large pc-board on the door of the cabinet. Make
sure all six of the small connectors on the column and the
large connector on the pc-board are plugged in and seated
firmly. Power off the instrument and power it back on. If the
error remains, contact TSI.
59 Electrometer PCB 2 Error
60 Electrometer PCB 3 Error
61 Electrometer PCB 4 Error
62 Electrometer PCB 5 Error
63 Electrometer PCB 6 Error