Triumph 2010 Tiger 800, Руководство по обслуживанию

Страница: 298 / 508

Fuel System/Engine Management
5. Tighten the header pipe to cylinder head nuts in the
sequence shown below:
•
Stage 1 : Tighten the header pipe nuts to
2 Nm.
•
Stage 2: Tighten the header pipe nuts to
19 Nm.
Header Pipe Tightening Sequence
6. Tighten the rear mounting point fixing to
19 Nm.
Z
Refit the radiator and refill the cooling system <see
page 1 1-12>.
8. Reconnect the oxygen sensor and route the harness
under the sump guard as noted on disassembly.
9.
Refit the sump guard (see page 16-21).
10. Position and engage the silencer to the header pipe.
Do not tighten the clamp at this stage.
1 1. Align the silencer mounting bracket to the rear
frame bracket. Refit the nut. Tighten the fixings to
1 5 Nm.
Align the clamp for the silencer to header pipe joint
as shown below and tighten to
10 Nm.
1. Silencer intermediate pipe
2. Clamp
3. Header pipe
13. Reconnect the battery, positive (red> lead first.
Do not install the exhaust system or run the engine
without the exhaust heatshields fitted. Components
protected by the exhaust heatshields may suffer severe
damage or a fire if the motorcycle is operated without
the heatshields being fitted.
14. Start the engine and check for exhaust gas leaks.
Rectify if necessary.
15. Refit the rider's seat <see page 16-13>.
10. 120
SeJVice Manual
-
Tiger 800 and Tiger 800XC