Triumph 2010 Tiger 800, Руководство по обслуживанию

Страница: 22 / 508

General Information
Circuit Diagrams
Circuit diagrams are created to provide a 'picture' of the
electrical system and to identify the route taken by each
individual wire through the system, in order to identify
which components it feeds and which connectors the wire
runs through. Circuit diagrams are an essential tool for
fault finding, as it is possible to locate start and finish
points for a circuit without l')aving to manually trace the
wire through the motorcycle itself. Circuits diagrams may
look confusing at first but when they are studied closely
they soon become logical.
Due to the complex circuits and the number of individual
wires, Triumph uses two types of circuit diagram in its
service manuals.
c
•
Within the manua ' l conventional circuit
diagrams are used to show the layout of the
main circuits of the motorcycle. These are:
Engine
managemenUignition, Lighting,
Starting and Charging and Auxiliary and
Accessory. In these diagrams no attempt is
made to show the components of the system
in any particular order or position in relation
to the motorcycle.
At the back of the service manual a full
colour layout circuit diagram is used to show
the main electrical components in a position
similar to the actual position on the
motorcycle.
Both of these circuit diagrams use similar symbols to
illustrate the various system components and will be
accompanied by a key to circuit diagram components and
wiring colour codes.
Circuit diagrams also depict the inner workings of a switch
cube (I.E. which wire connects to which when a switch is
turned from one position to another) so that a test of that
switch can be made using the wire terminals in the
connector instead of disassembling the switch itself.
Glossary of Circuit Diagram Symbols
The following is a description of the symbols found in the
circuit diagrams used in all Triumph service manuals.
Connector
This illustration is used to show all multi-plug type
electrical connectors on Triumph circuit diagrams. The
numbers in the box relate to the terminal numbers of the
connector pins. On ECMs with two connectors, the
number would be prefixed with the letters 'A' or 'B' to
identify each connector. An additional number outside the
box will identify the component.
Diode
An electrical one-way valve. Diodes allow current to flow
in one direction but will not allow it to return. The arrow,
which forms part of the diode symbol, indicates the
direction of current flow.
Electromagnetic Winding <solenoid)
An electromagnetic winding (or solenoid) is used to
convert an electrical current into a lateral movement. This
can then be used to operate switches (as used in relays> or
other components such as fuel injectors or secondary air
injection solenoids.
Fuse
�2
or
�3
A fuse is a device which protects a circuit in the event of a
fault. The fuse will 'blow' should a short circuit occur,
protecting that circuit from further damage. The number
next to the fuse on the circuit diagram indicates the
position of the fuse in the fusebox.
1.14
SeiVice
Manual
-
Tiger
800 and
Tiger -
800XC