Triumph 2010 Tiger 800, Руководство по обслуживанию

Страница: 391 / 508

Rear ABS Wheel Speed Sensor
Removal
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Remove the rider's seat <see page 16-13).
2. Remove the battery <see page 17-8)
3. Disconnect the wheel speed sensor multiplug,
located under the battery.
•
Note the routing of the ABS sensor harness
for installation.
4. Detach the ABS sensor harness from its clips on the
rear brake hose.
5. Release the fixing securing the wheel speed sensor
to the rear brake caliper carrier and remove the
sensor. Collect the shim and discard the fixing.
1. ABS sensor
2. ABS harness bracket
3. Fixing
4. Shim<s>
Brakes
Installation
Note:
1.
2.
3.
4.
5.
6.
z
8.
•
Check the condition of the shim before use.
Do not use a shim which is bent or
damaged.
Position the shim to the fixing such that it will be
installed between the wheel speed sensor and the
brake caliper carrier.
Fit the wheel speed sensor, harness bracket and
shim to the brake caliper carrier as noted during
removal.
Temporarily fit the original bolt and tighten to
9 Nm.
The air gap between the wheel speed sensor and the
pulser ring must be between 0.1 mm and 1.5 mm.
Check and adjust the wheel speed sensor air gap as
described on page 14-3 8.
Once the wheel speed sensor air gap measurement
is correct, install a new bolt (if not already replaced
during air gap adjustmenO and tighten to
9 Nm.
Attach the ABS sensor harness to its clips on the
brake hose.
Connect the wheel speed sensor multiplug.
Refit the battery (see page 17-8).
Refit the rider's seat (see page 16-13).
9. Check that the brakes operate correctly.
SeiVice Manual
-
Tiger 800 and Tiger 800XC
14.37