Triumph 2010 Tiger 800, Руководство по обслуживанию

Страница: 143 / 508

Assembly
Note:
•
The numbers in brackets in the following
text refer to the exploded view on
page
7-14.
•
Lubricate each gear, thrust washer and bush
with clean engine oil during assembly.
!
When using a press, always wear overalls, eye face and
hand protection. Objects such as bearings frequently
break-up under load and the debris caused during
break-up may cause damage and injury to unprotected
parts of the body.
Never wear loose clothing, which could become trapped
in the press and cause crushing injuries to the hand,
arms or other parts of the anatomy.
Removing the input shaft bearing from the shaft and its
housing will damage the bearing. Never re-use
removed bearings as use of damaged or weakened
components could lead to engine and transmission
damage. Also, check for damage to the housing itself.
1 .
Position the bearing to the housing.
Press only on the bearing outer race to prevent bearing
damage.
Transmission
2.
Support the housing on press bars as shown below
and press the bearing fully into the housing in the
direction of the arrow.
1. Bearing housing
2. Bearing
2
Press only on the bearing inner race to prevent bearing
damage.
·
3 .
Locate the bearing and housing to the input shaft.
Carefully support the shaft on the press bed, and
using a suitable sleeve over the input shaft to ensure
the bearing is pressed only on the inner race, press
the bearing onto the shaft.
1. Sleeve
2. Bearing/housing
3. Press bars
4. Input shaft
4. Fit the plain bush
< 1 3>
to the shaft.
5. Fit fifth gear
( 1 2)
to the input shaft as noted during
disassembly, with the dog teeth pointing away from
the input shaft bearing.
6. Slide on the splined thrust washer
( 1 1 >.
SeNice Manual
-
Tiger 800 and Tiger 800XC
7.15