Triumph 2010 Tiger 800, Руководство по обслуживанию

Страница: 14 / 508

General Information
If there has been an appreciable drop in the level of the
fluid in either brake fluid reservoir, consult your
authorised Triumph dealer for advice before riding.
If the brake lever or pedal feels soft when it is applied, or
if the lever/pedal travel becomes excessive, there may
be air in the brake lines or the brake may be defective.
lt is dangerous to operate the motorcycle under such
conditions and remedial action must be taken by your
authorised Triumph dealer before riding the motorcycle.
Failure to take remedial action may reduce braking
efficiency leading to an accident.
Use only DOT
4
specification brake fluid as listed in the
general information section of this manual. The use of
brake fluids other than those DOT
4
fluids listed in the
general information section may reduce the efficiency of
the braking system leading to an acci
�
ent.
Failure to change the brake fluid at the interval specified
in the routine maintenance schedule may reduce
braking efficiency resulting in an accident.
'
e
Never use mineral based grease in any part of the
braking system or in any area where contact with the
braking system is possible. Mineral based grease will
damage the hydraulic seals in the calipers and master
cylinders.
Damage caused by contact with mineral based grease
may reduce braking efficiency resulting in an accident.
'
•
Before installation, all internal brake components should
be cleaned and lubricated with clean n�w DOT
4
brake
fluid.
Never use solvents, petrol (gasoline), engine oil, or any
other petroleum distillate on internal brake components
as this will cause deterioration of the hydraulic seals in
the calipers and master cylinders.
A dangerous riding condition leading to loss of
motorcycle control and an accident could result if this
warning is ignored.
Safety Instructions
Jacking and Lifting
Always ensure that any lifting apparatus has adequate
load and safety capacity for the weight to be lifted.
Ensure the motorcycle is well supported to prevent any
possibility of the machine falling during lifting or jacking,
or while repairs and servicing are carried out.
Never rely on a single means of support when working
with the motorcycle. Use additional safety supports and
straps to prevent toppling.
Do not leave tools, lifting equipment, spilt oil, etc. in a
place where they could become a hazard to health.
Always work in a clean, tidy area and put all tools away
when the work is finished.
Precautions against Damage
Avoid spilling brake fluid or battery acid on any part of the
bodywork. Wash spillages off with water immediately.
Disconnect the battery earth lead before starting work, see
ELECT RICAL PR ECAUTIONS.
Always use the recommended service tool where
specified.
Protect exposed bearing and sealing surfaces, and screw
threads from damage.
Coolant
Coolant mixture, which is blended with anti-freeze !3nd
corrosion inhibitors contains toxic chemicals which are
harmful to the human body. Never swallow anti-freeze,
corrosion inhibitors or any of the motorcycle coolant.
Do not remove the radiator cap when the engine is hot.
When the engine is hot, the coolant inside the radiator is
hot and also under pressure. Contact with the
coolant will cause scalds and skin damage.
1.6
SeJVice
Manual
-
Tiger
800 and
Tiger
800XC