Trinity Highway QuadGuard Elite M10 Wide, Руководство по сборке изделия

Страница: 14 / 68

TrinityHighway.com 13 Revision A August 2020
Cutting equipment

Rotary Hammer Drill

Rebar cutting bit

Concrete drill (Double Fluted*) bits –7/8” [22 mm]

Grinder, Hacksaw or Torch (optional)

Drill motor

Drill bits 1/16” through 7/8”
Important:
Trinity Highway recommends using Double Fluted drills to achieve
required tensile strength when assembling the approved anchoring system.
Hammers

Sledgehammer

Standard hammer
Wrenches

Heavy duty impact wrench

Standard adjustable wrench

1/2" drive Sockets: 9/16", 11/16", 3/4", 15/16", 1 1/8", 1 1/4"

1/2" drive Deep Sockets: 15/16", 1 1/4"

1/2" drive Ratchet and attachments

1/2" drive Breaker Bar - 24" long

1/2" drive Torque Wrench: 200 ft.-lbf.

Crescent Wrench: 12” [300 mm]

Allen Wrench: 3/8”

Impact Wrench: 1/2"
Miscellaneous

Traffic control equipment

Lifting and moving equipment - Minimum 5,000 lb. capacity required

Air Compressor (100 psi) and Generator (5 kW)

Pry bar

Drift pin 300 mm [12”]

Center punch

Tape measure 25’ [7.5 m]

Chalk line

Concrete marking pencil

Nylon bottle brush for cleaning 7/8” drilled holes

Rags, water, and solvent for touch-up

Chain, 3/8” grade 40, 20’ [6 m] with 1/2” [13 mm] hooks

Acetylene torch
Note:
The above list of tools is a general recommendation and should not be considered
a complete list. Depending on specific site conditions and the complexity of the assembly
specified by the appropriate highway authority, the required tools may vary. Decisions as
to what tools are needed to perform the job are entirely within the discretion of the
specifying highway authority and the authority’s selected contractor performing the
assembly of the system at the authority’s specified assembly site.