Trafox SUPERINTEND IC-01, Инструкция по установке и эксплуатации, Страница: 43 / 73

Superintend IMD © Copyright Muuntosähkö Oy - Trafox 43
http://www.trafox.fi
Measure Failure OFF
The insulation resistance
measurement can be
performed after an internal
fault has been corrected.
Wire Ampl Test Fail [ N ][ L ]
The Wire Test amplitude is too
low (
N , whereas the alarm
limit is L ) -> M1 has been
disconnected from the network
to be measured.
Wire Ampl Test OK
The Wire Test amplitude has
recovered to the correct level;
M1’s connection to the network
to be measured has been
restored.
Wire Offset Test Fail [ N ADP][ L ADP]
The Wire Test offset is too
small (
N , whereas the alarm
limit is L ) -> M1 or M2 has
been disconnected from the
network to be measured.
Wire Offset Test OK
The Wire Test offset has
recovered to the correct level;
the M1 and M2 connections to
the network to be measured
have been restored.
Too much noise [ N %][ L %]
The insulation resistance
measurement continuously has
a noise level too high (N)
whereas the alarm limit is
L .
Noise normal level
The noise level of the
insulation resistance
measurement has returned to
normal.
PE Alarm ON [PE XX CH CC ][ N ][ L ]
The resistance fault of channel
CC of the PEC-01 unit in the PE
address of XX has been
activated with value N ,
whereas the limit value has
been
L .
PE Alarm OFF [PE XX CH CC ]
The resistance fault of channel
CC of the PEC-01 unit in the PE
address of XX is no longer
active.
PE Alarm Acknowledge [PE XX CH CC ]
The resistance fault of channel
CC of the PEC-01 unit in the PE
address XX is no longer active.
The alarm was acknowledged
manually.
Alarm Limit changed [PEresist] [ L1 %]->[ L2 %]
The limit value of the
resistance fault of the PEC-01
units was changed from
L1 to
L2.
Missing TC Alarm ON [TC XX ]
The TC-01 unit configured in
the TC address
XX is not
responding.
Missing TC Alarm OFF [TC XX ]
The TC-01 unit configured in
TC address
XX is responding