Toyota Celica 2005, Руководство по ремонту

Страница: 2318 / 2497

H12228
4 Clips
H12229
BO − 12
− BODY FRONT DOOR
2005 CELICA (RM1131U)
5. REMOVE DOOR TRIM
(a) Using a screwdriver, remove the 2 plug hole covers.
HINT:
Tape the screwdriver tip before use.
(b)
Remove the 6 screws.
(c) Insert a screwdriver between the door panel and door trim
to pry the trim out.
HINT:
Tape the screwdriver tip before use.
(d) Pull the trim upward to remove it, then disconnect the
locking cable and open cable from the door inside handle.
HINT:
S
At the time of reassembly, please refer to the following
items.
S
Check that a ball at the end of the locking cable is
pressed. (The cable should be locked.)
S
Turn the locking knob of the inside handle fully to the lock
side and install the locking cable.
(e) Remove the screw and door inside handle from the door
trim.
(f) Using a screwdriver, remove the front door inner weather-
strip from the door trim.
6. REMOVE DOOR SIDE AIRBAG SENSOR
NOTICE:
S
If the wiring connector of the SRS is disconnected
with the ignition switch in ON or ACC position, DTCs
will be recorded.
S
Never use SRS parts removed from another vehicle.
When replacing parts, replace them with new ones.
S
Never reuse the sensor involved in a collision where
the SRS has deployed.
S
Never repair a sensor in order to reuse it.
Disconnect the connector, then remove the 2 bolts and door
side airbag sensor.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
NOTICE:
S
At the time of reassembly, please refer to the follow-
ing items.
S
Make sure the sensor is installed in the specified
torque.
S
If the sensor has been dropped, or there are cracks,
dents or any other defects are identified in the case,
brackets or connector, replace the sensor. Always re-
place the set bolts with new ones.
S
The sensor set bolts have been anti − rust treated.
When the sensor is removed, always replace the set
bolts with new ones.
S
After installation, shake the sensor to check that
there is no looseness.
2317