Toyota Celica 2005, Руководство по ремонту

Страница: 1678 / 2497

B00231
Wooden Block
20 mm
40 mm
37 mm
(kgf/cm
2
) = Ram diameter (cm)
2
x 3.14( π )
100 kgf
2
(psi) = Ram diameter (in.)
2
221 ibf
2
x 3.14 ( π )
(kpa) = (kgf/cm
2
) x 98.1
(kpa) = (psi) x 6.9
B00411
SST
B00323
ST − 12
− STARTING STARTER
2005 CELICA (RM1131U)
(g) Tighten terminal nut.
(1)
Put a wooden block on the contact plate and press
it down with a hand press.
Dimensions of wooden block:
20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force:
981 N (100 kgf, 221 Ibf)
NOTICE:
Check the diameter of the hand press ram. Then calculate
the gauge pressure of the press when 981 N (100 kgf, 221
Ibf) of force is applied.
Gauge pressure:
If the contact plate is not pressed down with the specified pres-
sure, the contact plate may tilt due to coil deformation or the
tightening of the nut.
(2) Using SST, tighten the nuts to the specified torque.
SST 09810 − 38140
Torque: 17 N·m (173 kgf·cm, 12 ft·lbf)
NOTICE:
If the nut is over tightened, it may cause cracks on the in-
side of the insulator.
(h) Clean contact surfaces of contact plate and plunger.
Clean the contact surfaces of the remaining contact plate
and plunger with a dry shop rag.
(i) Reinstall magnetic switch end cover.
Install the plunger, new gasket, and cover with the 3 bolts.
Torque: 2.5 N·m (26 kgf·cm, 23 in.·lbf)
1677