Toyota Celica 2005, Руководство по ремонту

Страница: 2021 / 2497

F09541
BR14C − 03
F09542
F09543
F09783
F09544
BR − 34
− BRAKE REAR BRAKE PAD
2005 CELICA (RM1131U)
REPLACEMENT
1. REMOVE REAR WHEEL
2. INSPECT PAD LINING THICKNESS
Check the pad thickness.
Minimum thickness: 1.0 mm (0.039 in.)
3. REMOVE CLIP, 2 ANTI − RATTLE SPRINGS AND 2 PAD
GUIDE PINS
(a) Using a screwdriver, remove the clip and 2 anti − rattle
springs.
NOTICE:
S
Do not deform the clip and anti − rattle spring.
S
The clip and anti − rattle spring can be used again pro-
vided that they have sufficient rebound, no deforma-
tion, cracks or wear, and have had all rust, dirt and for-
eign particles cleaned off.
(b) Remove the 2 pad guide pins.
4. REMOVE PADS AND ANTI − SQUEAL SHIMS
(a) Remove the 2 pads.
(b) Remove the anti − squeal shim from each pad.
5. CHECK DISC THICKNESS AND RUNOUT (See page
BR
− 39)
6. INSTALL NEW PADS
NOTICE:
When replacing worn pads, the anti
− squeal shims must be
replaced together with the pads.
(a) Apply disc brake grease to inside of anti − squeal shims
(See page BR − 33).
(b) Install the anti − squeal shim on each pad.
(c) Draw out a small amount of brake fluid from the reservoir.
(d) Press in the piston with a hammer handle or equivalent.
HINT:
S
Tape the hammer handle before use.
S
If the piston is difficult to push in, loosen the bleeder plug
and push in the piston while letting some brake fluid es-
cape.
(e) Install the two brake pads with the anti − squeal shims to
the brake caliper.
(f) Install the two guide pins to fix the brake pads.
2020