Toyota Celica 2005, Руководство по ремонту

Страница: 1501 / 2497

A10400
A01152
New O − Ring
A01231
M/T
1
2
3
4
5
6
7
8
A01232
M/T
Painted Mark
90 °
− ENGINE MECHANICAL CYLINDER BLOCK
EM − 115
2005 CELICA (RM1131U)
24. 2ZZ − GE:
INSTALL VENTILATION CASE
(a) Install a new gasket and ventilation case with the 3 bolts.
Torque: 8.5 N·m (87 kgf·cm, 75 in.·lbf)
(b) Install the No. 3 ventilation hose and connect the clip.
25. INSTALL THERMOSTAT (See page CO − 11)
26. INSTALL WATER BYPASS PIPE
Torque:
1ZZ
− FE 9.0 N·m (92 kgf·cm, 80 in.·lbf)
2ZZ − GE
Bolt 8.5 N·m (87 kgf·cm, 75 in.·lbf)
Nut 10 N·m (100 kgf·cm, 7 ft·lbf)
27. 1ZZ − FE:
INSTALL OIL DIPSTICK AND GUIDE
(a) Install a new O − ring on the dipstick guide.
(b) Apply soapy water on the O − ring.
(c) Connect the dipstick guide end to the main bearing cap.
(d) Install the dipstick guide with the bolt.
Torque: 11 N·m (113 kgf·cm, 8 ft·lbf)
28. INSTALL CYLINDER HEAD (See page EM − 67)
29. INSTALL ENGINE WIRE
30. INSTALL TIMING SPROCKETS AND TIMING CHAIN
(See page EM − 26)
31. REMOVE ENGINE STAND
32. M/T:
INSTALL FLYWHEEL
HINT:
The flywheel bolts are tightened in 2 progressive steps, (a) and
(c).
(a)
Install and uniformly tighten the 8 mounting bolts, in sev-
eral passes, in the sequence shown.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
(b) Mark the flywheel bolt with paint.
(c) Retighten the flywheel bolts by an additional 90 ° .
(d) Check that the painted mark in now at a 90 ° angle to (b).
1500