Toyota Celica 2005, Руководство по ремонту

Страница: 885 / 2497

AT3417
OK if hot
Add if hot
DI − 686
− DIAGNOSTICS AUTOMATIC TRANSAXLE (U240E)
2005 CELICA (RM1131U)
(c) 2 position test
Shift into the 2 position and fully depress the accelerator pedal and check the following points.
(1)
Check up − shift operation.
Check that the 1 → 2 up − shift takes place and that the shift point conforms to the automatic shift
schedule (See page SS − 42).
HINT:
There is no O/D up
− shift and lock − up in the 2 position.
(2) Check engine braking.
While driving in the 2 position and 2nd gear, release the accelerator pedal and check the engine
braking effect.
(3) Check for abnormal noises during acceleration and deceleration, and for shock at up − shift and
down − shift.
(d) L position test
Shift into the L position and fully depress the accelerator pedal and check the following points.
(1)
Check no up − shift.
While driving in the L position, check that there is no up − shift to 2nd gear.
(2) Check engine braking.
While driving in the L position, release the accelerator pedal and check the engine braking effect.
(3) Check for abnormal noises during acceleration and deceleration.
(e) R position test
Shift into the R position, lightly depress the accelerator pedal, and check that the vehicle moves back-
ward without any abnormal noise or vibration.
CAUTION:
Before conducting this test ensure that the test area is free from people and obstruction.
(f) P position test
Stop the vehicle on a grade (more than 5
° ) and after shifting into the P position, release the parking
brake. Then, check that the parking lock pawl holds the vehicle in place.
11. BASIC INSPECTION
(a) Check the fluid level.
HINT:
S
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temp.: 70 to 80 ° C (158 to 176 ° F)
S
Only use the COOL range on the dipstick as a rough refer-
ence when the fluid is changed or the engine does not
run.
(1) Park the vehicle on a level surface and set the park-
ing brake.
(2) With the engine idling and the brake pedal de-
pressed, shift the shift lever into all positions from P
to L position and return to P position.
(3) Pull out the dipstick and wipe it clean.
(4) Push it back fully into the pipe.
884