42
Configuring the RemotEye II via Telnet
The RemotEye II can be configured by establishing a telnet session with the device.
Hardware Setup
Telnet configuration is accomplished through a network link. Follow these steps to
setup the hardware for telnet RemotEye II configuration:
Verify network cable connection to NETWORK port of RemotEye II.
Verify active link to LAN or Network.
For further information on the network connection, refer to Making the Network
Connection on page 20.
Software Setup
The telnet configuration is accomplished through a TCP/IP network connection. A
telnet connection can be established with RemotEye II by using any telnet application.
Follow these steps to setup the software for telnet RemotEye II configuration:
Verify workstation is loaded with Telnet application.
Verify a valid network path exists between the RemotEye II and the workstation. If
performing the telnet configuration from a workstation that is located on the same
network, then proceed to the next section to the section, Connecting to the RemotEye
II via Telnet on page 44, otherwise, continue with the next section Routing to the
RemotEye II on page 43.
