Toshiba MMY-MAP0724HT6UL, Руководство по обслуживанию

Страница: 216 / 241

215
9 Pipe fixing rubber
- detachment/
attachment
(common)
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving
a replacement part or some other object.
1. Detachment
1) Hold the pipe fixing rubber in such a
manner that your fingers and thumb are in
contact with the two longitudinal ends of the
piece, and squeeze it a little to create a
small gap between the rubber and the SUS
band wrapped around it.
2) Push the hook end of the SUS band down
to disengage the hook from the square
hole.
2. Attachment
1) The pipe fixing rubbers use a two-segment
design to accommodate a wide range of
pipe combinations. When installing them,
therefore, it is recommended to first split
them up into segments and pair the
segments up only after placing them on
pipes of matching sizes separately. In this
regard, make sure that the mating tooth and
slit of pairing segments face each other.
2) When placing an SUS band around pipe
fixing rubber, make sure that the hook end
of the SUS band coincides with the slit side
of the rubber. (The band can be placed the
other way around, but only at the expense
of work efficiency.)
3) Place the SUS band tightly around the pipe
fixing rubber so that there is no gap
between them.
Take utmost care not to create a gap over
the curved section of the rubber where the
hairpin side of the band is located.
4) While holding the rubber, press down the
base of the hook lightly against the rubber,
and engage the hook with the square hole
by squeezing the curved section of the
rubber where the square hole side of the
band is located (see the arrow).
(If the hook does not engage with the
square hole, recheck whether there is a gap
between the band and rubber.)
No. Part to be replaced Work procedure Remarks
Squeeze rubber to create small gap.
Push band down in arrow direction.
Place two segments of damper on pipes of
matching sizes separately, making sure tooth and
slit of pairing segments face each other.
Align tooth and slit and push two
segments towards each other.
Make sure that hook end of SUS band
coincides with slit side of rubber.
Slide it along.
Place band tightly around rubber
without a gap between them.
Push square hole end of tape in
arrow direction by squeezing rubber.
Press down hook side of
tape against rubber.